1. Test the water using a good quality test kit
2. Check the filter pressure, and if needed backwash
3. Clean the tile
4. Skim the surface and remove the large debris
5. Vacuum
6. Brush any remaining dirt from the walls.
7. Clean out the skimmer and pump baskets
8. Add the chemicals needed to maintain proper sanitation and water balance
9. Check the time clock trippers for proper run cycles
10. Check for proper water level
1. No water in the pump strainer pot6
2. Strainer pot lid is not tight
3. Damaged lid O ring
4. Water level is below skimmer
5. Strainer or skimmer basket is clogged
6. Closed valve in piping system
7. Pump is on low speed (two-speed ) units only
8. Air leak in the suction line
1. Filter is dirty
2. Restriction in the return line
3. Strainer basket or skimmer basket is clogged
4. Clogged impeller
5. Air leak in suction line
6.Restriction in suction line
1. Power switch is off.
2. Circuit breaker is tripped
3. Pump is in off mode of timer controlled circuit
4. Motor terminal connections are incorrect
5. Motor shaft is locked by a bad bearing
6. Impeller is locked by debris
1. Electrical supply connections are incorrect
2. Wiring to pump is undersized
3. Power company supply voltage is low
4. Ventilation is inadequate for motor